Pendant rope weaving course

Preparation tools: pendant, pendant rope, scissors, lighter.

1. First cut a piece of jade rope, about 25 cm, the thickness depends on the size of the hole in the pendant. Burn one end of the jade rope and taper it with your fingers.

2. The jade rope passes through the hole on the pendant, as long as the front and rear ropes are the same.

3. Wrap the jade rope around the lanyard.

4. Leave a distance of about 3 mm between the lanyard and the pendant for knotting. Pinch the lanyard with your fingers and insert the jade rope as shown in the figure below. Right jade rope at the bottom, left jade rope at the top, cross.

5, tighten the rope, the effect is as follows. This knot is a bit loose, so you should pinch your fingers.

6. Tie the second knot in the same way. This knot is the opposite of the first one, and the jade rope on the right is on it and crosses.

7, tighten the jade rope, the effect is as follows, this rope is tight.

8. Tie another knot in the same direction as the first knot, as shown in the figure below.

9, tighten the jade rope, the effect is as follows.

10, cut off the redundant jade rope, and then burn the thread with a lighter.

1 1. The line was melted and squashed with your fingers.

12. In this way, a knot is woven.