How to disassemble and clean the mahjong table

Take mahjong machine down, then use a screwdriver to remove the screws at the four corners, and then you can remove the four legs. If it is an iron foot, you need to remove the four screws connecting the foot and the mahjong machine chassis. Note that it is the screw connecting the foot and the chassis, not the screw connecting the chassis and the mahjong machine bottom plate.

The surface layer on the back of mahjong tiles contains magnets and other things that can be attracted by magnetic force, but not on the front. Sticking a suction ring on the back of mahjong tiles can attract magnetic force, but the strength of the front of mahjong tiles is weakened due to a certain thickness, which is not enough to attract mahjong. Actually, it depends on electromagnets, so ordinary mahjong can't be used. ).

The card rotates with the disk on the inclined disk. When the card rises to a high place, the card with its back facing upwards is attracted by the magnetic ring on the shuffling bucket and is sent to the conveying slot along with the rotation of the magnetic ring. They are pushed into the pier by the stacking motor at the head of the machine and pushed away by the chain bar, while the cards facing upward continue to rotate on the disc. After folding in pairs, the cards on the slot are distributed in all directions by the push rod.

There is a small spring on the disc to turn the cards, so that the cards on the front will turn down and the cards on the back will be attracted by the magnetic ring until all the cards are finally sent to the slot and taken away. When there are enough cards on all sides, people will control the lifting button on the operation panel, and the tray under the cards will send the cards folded on all sides out of the table.