How to repair damp old photos?

When we open the old photos, some photos have begun to turn yellow, become old and even blurred, and we want to develop them again. At this time, you need to use photoshop to process the old photos and completely repair them. I would like to remind you that it is a little difficult for people who don't have a certain ps skill in art to repair worn-out photos, at least hand-drawn skills can. Repairing people's worn photos with ps requires hand-drawing skills. Because in the process of restoration, it is necessary to deepen layer by layer, first repair the missing parts in the picture, then deal with the rough color blocks and layers, and then depict the details later. If the picture is gorgeous, you can turn it into black and white effect first, and then color it.

1.ps Open the old photo, and ctrl+j copy one layer, and execute: Image-Adjustment-Channel Mixer.

Second, the image-adjustment-automatic comparison, the effect is shown in the figure.

3.ctrl+j copy a layer to get a copy of layer 1, and use the noise reduction filter.

Fourth, ctrl+j copies a layer, and the stamp tool cleans up the dirty spots on the face.

5. Create a new layer to get layer 2. Brush tool absorbs low opacity and flowing good skin color, and fills the missing highlights of the face. Clothes and hair are also repaired.

6. Merge layer 2 down, and now it is a copy of layer 1.

7. Copy 2 of layer 1 and then use ctrl+j to copy a layer to get copy 3 of layer 1. Copy 3 Gaussian blur 4 pixels, add layer mask, and reverse the white mask to black mask. Select the brush tool, the opacity is about 60, the flow rate is about 65, pay attention to the front white and then black, and wipe off the uneven skin on the mask to make it even.

8. Merge copy 3 of layer 1 with copy 2 of layer 1. It is now 1 floor. Copy 2 is on the top, four floors in all. Copy one layer every time you go to the next step. If this step is not done well, we can delete it, but the previous effect is reserved and will not waste time. )

Nine, ctrl+j copy a layer. In this step, we will use deepening and lightening to make the outline of the five senses. First use the fade tool to fade the whites of the eyes, and then use the deepen tool to deepen the eyes. Because the beads are round and the upper eyelid has eyelashes, the upper eyeliner is deeper than the lower eyeliner. In this way, the eyes will be clear.

Ten, do the other eye in the same way. Pay attention to the shape of your eyes. Many people's eyes are not exactly the same, they will be different. Of course, sometimes you can copy one eye to the other, but you must be careful not to be completely symmetrical with the original shape, but to be slightly deformed. Two eyes to complete.

1 1. Deepen the contours of the nose and nostrils on both sides and the contour of the mouth with the exposure of 9% to 15% of the deepening tool. Just be moderate, not excessive. The seam in the mouth should be deepened.

Now deepen the contours of the face, clothes and ears.

Thirteen, a new layer, draw the path of half the hair with a pen and ink.

Fourteen, choose the brush tool to choose a stroke path of a point hairbrush.

15. copy the left hair ctrl+j to the right, erase the cross part with an eraser, and merge the hair layers on both sides. Gaussian blur 2.5.

Sixteen, use the smudge tool to choose a point brush and hook the hair on the edge of the hair.

Seventeen. As shown in fig. 2 1 19, the hair layer is deformed to fit the shape of the head with a deformation tool. Change the opacity of the hair layer to 74% and the filling degree to 49%.

18. Change the opacity of the hair layer to 74% and the filling degree to 49%.

Nineteen. Brightness contrast of modulation layer: +5/+ 17.

Twenty, done.