Excuse me, are the injection workers in the plastic factory working hard?

Almost all injection molding plants have two shifts. Although the wages of injection molding plants are generally higher than those of assembly lines, there is still a serious shortage of people. Nowadays, the manipulator has become the standard configuration of injection molding machine. No matter whether it is a big factory or a small factory, a manipulator is always installed on the injection molding machine, which solves the difficulty of recruitment and reduces the labor cost.

1, ordinary plastic workers, with the largest population.

2. Ordinary plastic workers' educational background is generally low.

3. The length of service of ordinary plastic workers is generally low.

For many ordinary plastic workers, they are in an embarrassing stage. Because of their low academic qualifications, they are trying to learn new technologies, and their work experience is relatively low, so they will face a stage of high success rate and low success rate when they are employed. Due to lack of education and experience, their employment benefits will be very low.

The old plastic master in the expansion material factory

1, with low academic qualifications.

2, the length of service is too long

3. The treatment is high

For many enterprises, the old plastic masters were plastic workers in the 1970s and 1980s. In the 1970s and 1980s, people generally had low academic qualifications and could master the previous equipment skillfully. However, for the new equipment technology, due to their academic qualifications, it is difficult to accept the new technology, and they can only master it by experience, and their age is relatively high, so they will face the stage of retirement.