A complete collection of fishhook binding methods

1. This method, usually called Nihili hook method, winds the fishing line around the hook handle for about two turns, and then tightens it.

2. After the fishing line is wound four or five times on the hook handle, pass one end of the previously reserved fishing line through the coil and tighten it.

3. Wind the fishing line from the bottom of the hook handle, and after a certain number of turns, leave a part of the thread end taut. It is easier to fish in the direction opposite to the hook tip, so after tying the hook, the hook tip should be as outward as possible.

4. First tie a fishing line with proper length to the hook and wrap it around the hook handle for five or six times. When the fishing line slides outward, block it with your fingers, and then slowly pull the end of the line when tightening. Another hook uses the same binding method. After fixing the hook distance, remove the double hook and tie the double thread, and finally tighten the small circle.

There are many ways to tie a knot. Many anglers like to use hook tying devices. First, prepare the hook handle and wind the fishing line around it.

1. Hold the hook with your left hand and bend the messenger wire into a circle at the same time. Pay attention to the thread ends on both sides, leaving enough length.

2. Hold the right wire of the coil interface by hand and wind the fishing line on the hook handle. Note that the right thread end and hook handle should be wound together at the same time.

3, a total of 4-5 laps, and it is not too easy. After winding the wire enough times, turn the winding wire to the left hand to pinch it, then hold the wire end of the winding wire with the right hand and pull it out until it reaches the wire end, and tighten it hard. At the same time, pay attention to avoid hurting the hook tip with too much force, and finally cut off the excess thread with scissors.