Self-decoration process

Self-decoration process (self-decoration process 1) tools are in place and ready.

Before decorating, you must prepare a few things and put them in your bag.

Tape measure (buy 5m, not 3m), calculator, big board clamp (for bills and receipts); In addition, it is best to prepare old towels (soft cotton, which will be used to wipe bricks after pasting) and plastic bags (wrapped around the pipe joints to prevent dirt from blocking) at the construction site in advance.

(2) Choose a good day and start shooting.

Before the workers enter the site, it is best to personally measure all corners of the house, write it down with a pen ruler and mark it clearly. Don't be lazy.

Clean up the areas involved in the renovation process. Especially tile area, wall paint area, wallpaper area and floor area; Determine the main wall size. Especially it is necessary to design the wall size of furniture in the future.

? (3) Self-transformation process: Dismantle the main body to make the space more practical.

The main body demolition and reconstruction is the first project, which mainly includes wall demolition, wall building, wall skin, heating (north) demolition, plastic steel window replacement and so on.

Remove the garbage in time to ensure the cleanliness of the room, but also for the convenience of construction.

At this point, it's time to set up the product door.

At this time, it is best to browse the cabinets, range hoods, cookers and water heaters and try to make sure.

(4) Hydropower transformation and arrangement of space use.

Hydropower transformation, no regret medicine to eat. Bricks are stuck on the wall and the ceiling is sealed, so it is difficult to add another socket.

So be sure to locate the switches, lights, basins, bathtubs, washing machines and so on.

Before the hydropower transformation, the cabinet designer should take measurements at home to help you determine the transformation scheme of power supply and waterway.

For water heaters, it is also best to send someone to design the position of the power supply and water interface according to the model you have determined.

* Remind you: it is best to leave a power socket on the wall below the washbasin to facilitate the installation of kitchen treasures.

* Air conditioning holes and power supply should be placed on the wall of the bedside as far as possible to avoid air conditioning blowing directly at people in the future.

* The distance between strong current and weak current should be 20 cm, for example, the distance between socket and network cable should be 20 cm.

(5) Self-decoration technology: guarantee the vertical pipe and ugly pipe.

Considering the humid environment of kitchen and bathroom, wooden keel must not be used as the material of riser!

Everyone must be careful, even if the wooden keel is painted with antirust paint.

Remember, the vertical pipe is made of light steel keel or red brick. Light steel keel saves space, but the most sturdy and easy to use is red brick.

* At this time, you need to buy tiles, jointing agents, etc.

* furniture should be set in advance, and the construction period should be kept well, at least 15 days, usually one month is better.

By the way, don't wrap the pipe where there is a hole. In case of water seepage, there is no reason.

(Self-decoration process 6) Sticking tiles must first have a solid texture.

Buy a floor drain before sticking bricks.

* Note: Floor drains should be bought in the local supermarket. Buy a special washing machine or floor drain for shower, and it should have deodorization function.

After waterproof napping, we are ready to stick bricks.

Normal tiles should be soaked in water, dried in the shade and then pasted; Broken tiles are left to cut.

Please leave more bricks before you buy them.

* At this time, the basin and faucet should be determined, and the cabinet designer should be invited to the door for the second time.

* At the same time, buy paint (ready mixed paint or transparent paint), wall paint, nitro paint, diluted water, etc. , such as wallpaper, must also be set up first.

(Self-decoration process 7) Oil workers go into battle and wash and brush.

There's nothing to say about painting the wall. Leveling, grinding and rolling must depend on the skill of your painter.

The primer has good adhesion, which can make the wall smoother, the topcoat easier to brush and reduce the use of topcoat. Moreover, the excellent sealing property of the primer can effectively resist the penetration of alkaline substances in the wall, prevent the precipitation of water-soluble salts and prevent the wall from returning to alkali.

* Need to remind everyone that if you want to paint the wall, you must pay attention to color matching. The adjusted color is lighter than the color card, and it must not be the same as or darker than the color card, otherwise you will regret it.

Because when you paint the wall at least twice, some even three times, the color of the upper wall will get darker and darker.

Different people have different views on whether to spray or roll coating. It is said that the spraying effect is better, but once it is damaged, it becomes extremely difficult to touch up the paint.

If you don't buy a finished door, let the worker master do it.

* Note: Any carpentry work, even if it is only a pass, should follow this step. The large core board sinks to the bottom and is faced before painting.

It is absolutely wrong to brush oil directly on the big core plate when adjusting oil. Don't believe the story of selling big core boards. It is no problem to brush oil directly on them.

Remember, brush the oil directly, and it won't take long for it to crack completely, remember to remember.

Now you don't have to brush mixed oil, but use spray. Workers had better spray white on the inside of the door and the meter box, which is beautiful and not wasteful.

(8) wallpaper, beautiful walls.

After the wall paint is painted, the oil trade union paints nitrocellulose paint where wallpaper needs to be pasted. The paint can be dried thoroughly the next day, and then the master is invited to paste the wallpaper.

At first, I was worried that pasting wallpaper would stain the painted white wall, but later I realized that pasting wallpaper was really a clean job! There is absolutely no need to worry.

* Note: Do not open the window for ventilation within 48 hours after the wallpaper is pasted, and let it dry slowly in the shade.

Tell the master that if something gets stuck, you should ask him to help repair it.

* It's time to buy panels, sockets and lamps.

(Self-decoration process 9) Install the socket panel

The socket panel can be installed in about half a day.

1, it's best to buy a socket with switch function, especially in the kitchen, so that the rice cooker and microwave oven can be controlled without plugging and unplugging the power supply.

2. Although the socket with switch is good, we should pay attention to practicality.

According to my observation, all three sockets of the five-hole power supply with switch are flat. Once your electrical appliance needs three round sockets, there will be the depression of using plug-in boards when the sockets are empty.

Therefore, multi-purpose sockets must be used, even if it has no switch control!

* At this point, the ceiling used in the bathroom and kitchen should be purchased.

* If you need to install Yuba at this time, please buy and install it in front of the ceiling.

(Self-decoration process 10) The ceiling of kitchen and bathroom is sealed with the last ugly part.

Install the water heater and Yuba first. After installation, the ceiling edge can better semi-package the water heater, that is, the connection is more beautiful.

* It is best to buy aluminum gusset ceiling. Even if it is demolished many years later, it is worth a lot of money to sell scrap aluminum.

On the other hand, pvc gusset plates look good, but the quality and performance are average, and plastic things are worthless even if they are sold as waste.

* When buying gusset plates, ask about the price of the whole package. Don't buy gusset plates and corners separately. But the installation fee is extra.

(1 1) Install cabinets, and a beautiful integrated kitchen is born.

Cabinets are cooperative projects, and range hoods, cookers and sinks should be arranged in advance.

It is best to deliver the goods on the same day and install them together with the cabinet.

Tell the cabinet factory in advance to bring the artificial stone countertops cut off from the stoves and sinks.

Things with more money can't be given to manufacturers for nothing. It is very useful to install a water meter and water pipe.

(Self-decoration process 12) Installation of finished door

The finished door should be installed before the floor, mainly because the installation steps of the door are complicated, such as hinge, door lock, door suction, door frame and so on. , and use a lot of tools. If the floor is installed first, it is difficult to avoid bumping.

In my house, the floor is installed first and then the door is installed. There are many small holes in the floor, and the meat hurts.

(Self-decoration technology 13) Installation of drying racks, curtain rods, lamps, sanitary wares and bathroom hardware. It is suggested that these projects with scattered ash should be settled one by one before installing the floor.

(14) Install the floor.

The floor must be leveled before installation. Seeing that many neighbors' floors are useless for leveling, they are careless.

Unexpectedly, after the floor was paved, the corridor was very flat and depressed. I had to take it off, pat it flat with instant powder and spread it again.

Prepare a little pepper in advance, don't buy the so-called insecticidal powder brought by the floor workers, just let them spread it along the kicking angle.

Workers must not cut the floor in the house, cut in the corridor and finally clean the corridor.

(self-healing process 15) recycling and cleaning

The biggest embodiment of cleanliness, I think, is to clean the glass.

It is a terrible thing to climb out and clean such a tall building.

Secondly, floor waxing, you have to buy your own wax, which is cheap and easy to use, but you must use a clean waxing machine, which is dozens of times faster than manual waxing.

As for the rest, I don't think we need to rely too much on cleanliness. They just scrape around with small blades, which is not smart.

So after cleaning, you'd better do a detailed cleaning yourself. Go to the supermarket to buy bags? Wu Jiefen? Bring some old towels.

Wipe old towels with dry five-clean powder, from door to door, from tiles to kicking corners, from one house to another. Don't be lazy. The result will surely make you proud.

(16) Furniture and household appliances enter the site.

A brand-new home, furniture bears the brunt. Bed, mattress, wardrobe, shoe cabinet, sofa, dining table, etc.

* Before the furniture enters the site, the following items should be prepared: disposable shoe covers (don't buy shoes with poor quality, they will break when you step on them), several boxes of activated carbon, ladders and floor protective film (it is best to protect the floor by carrying wardrobes and TV cabinets).

If you buy a cloth bed, remind you to see if all the cloth can be taken off.

Send home appliances quickly, and wait until money is tight or not in a hurry. Anyway, electrical appliances are more and more advanced and cheaper.

(Self-decoration process 17) Accessories are decorated, and the home has a taste.

With decorative paintings and beautiful curtains, the gentle taste of home comes out.

* Don't spend too much money on curtain accessories. Curtains and lead pendants are necessary, but lace, buttons and ears that cost eight yuan and ten yuan cost twenty or thirty yuan more per meter, which is unnecessary and not beautiful.