20 18 is February 29th the auspicious day for decoration? What should I pay attention to in decoration safety?

The renovation of a new house is a very complicated matter. Many friends have no time to take care of it because of work and other reasons. When decorating, it is easy to ignore some details of the decoration, which brings a lot of inconvenience to future life. 20 18 is February 29th the auspicious day for decoration? What should I pay attention to in decoration safety? 20 18 is February 29th the auspicious day for decoration? Lunar calendar 20 18 February 29 (lunar calendar)

Gregorian calendar 20 18 April 14 Saturday Aries (Gregorian calendar)

Today's almanac is appropriate.

Take the opportunity to marry the son-in-law and the son-in-law out.

Sacrifice, pray, move into the house and demand the release of the heir.

Collect money to go to the column planting post to file a lawsuit and enter the school.

Cut clothes, set up coupons, seek money, travel, buy a house, and seek medical treatment.

Today's old almanac is taboo.

Repair graves, bury beds, cut trees and build animals.

Litigation on breaking ground to build houses, bridges and embankments.

By looking at the Gregorian calendar, we found that there are foundation-laying projects on suitable days today, so February 29, 20 18 is an auspicious day for decoration; Precautions for decoration safety: 1. It should be noted that the floor of the building should not be paved with marble. The weight of marble is dozens of times that of floor tiles and wooden floors. If all marble is laid, the floor may be overwhelmed. Especially above the second floor, because the house decoration has not been appraised by the house safety appraisal station, the weight of ground decoration building materials shall not exceed 40 kg/m2.

2, balcony, bathroom decoration as far as possible to choose materials with small load, because the overloaded balcony will overturn.

3. When decorating the living room, it is not allowed to make holes in the load-bearing wall, dismantle the wall connected with the balcony and doors and windows, expand the original size of doors and windows or build new doors and windows. This will cause local cracks in the building, seriously affect the seismic capacity, thus shortening the service life of the building.

4. In order to pursue luxury in room decoration, it is not advisable to stick plates on the four walls and set two or three-dimensional ceilings on the ceiling. Because the walls are covered with plates, it takes up a lot of space, which will reduce the area of the whole space and the cost is high, which is not conducive to fire prevention. The low ceiling will make the whole room feel depressed.

Waterproofing between bathroom and bathroom is also the key link of decoration. The general practice is to block the floor drain before decorating the bathroom, put more than 5 cm of water, and carry out the water spraying test. If it leaks, it must be waterproof again; If there is no leakage, the ground should be carefully laid during construction, and the waterproof layer should not be destroyed, and the water supply and drainage and heating systems should not be changed without authorization.

6. During construction, attention should be paid to avoid drilling holes, drilling holes, ceiling and installing artistic lighting on the concrete circular hole plate.

7. Use copper wire when selecting the line, and avoid using aluminum wire. Due to the poor conductivity of aluminum wire, the wire is prone to heat, loose joints and even fire in use. In addition, during construction, attention should be paid to the fact that you can't directly dig trenches and bury wires on the wall, and you should adopt regular casing installation to avoid leakage and fire.

8. When decorating the kitchen, don't put the gas stove on the wooden cabinet, and you can't wrap the gas master valve in the wooden cabinet. Once the basement catches fire, it will be difficult to close the main gas valve in the fire, and the consequences will be unimaginable.

9, indoor decoration to ensure the safety requirements of gas pipelines and equipment, do not dismantle the pipeline without authorization, so as not to affect the normal operation of the system. In addition, it should be noted that the horizontal clear distance between power pipelines and equipment and gas pipelines should not be less than 10 cm, and the cross clear distance between wires and gas pipelines should not be less than 3 cm.