How to make the bed?

The installation steps of the bed are as follows:

1. First, install the three-in-one screw on the corner of the bed bag. As shown in the figure, one corner of the bed bag is butted with the bed side plate first, and then the other end is butted with the bed tail plate, and the other side of the bed side plate is also installed.

2. After installing the foot of the bed package, directly fix the foot code with the bed side plate and the bed tail plate with a 6mm flat head screw with an electric drill.

3. Then use 10 cm flat head screw to fix the foot of the bed on the screw hole in the middle of the foot code.

4. Fix the two square pins on the two side plates of the lathe bed with 6 mm flat head screws.

5. Fix the iron bar on two square feet with 6 cm flat head screws, and connect the two square feet to make the bedstead more firm.

6. Install three-in-one screws on the upper bed plate, the lower bed plate and the middle bed plate.

7. Then connect these boards with three pedals with three-in-one screws.

8. Install the decorative strip, first insert the wooden tenon into the footboard of the bed, and then connect the decorative strip.

9. Connect and fix the installed bed with the head of the bed, and then fix it in the hole of the side plate of the bed with a half-moon and m6 nut.

10, directly put the bed boards in the drawn order, and then put the mattress away, that is, complete the installation steps of simple bed installation.