20 19 toilet installation: only when it is installed in place can it be used safely.

Toilet, commonly known as toilet, has become the mainstream product for many family bathrooms because of its humanized design. Everyone should understand that if the toilet is improperly installed, it will easily cause annoying situations such as blockage in the future use process. Therefore, in order to have a more comfortable experience, in addition to buying toilet products with guaranteed quality, the installation of the toilet should also be strictly controlled. Next, let's learn about the installation of the toilet.

First, before installing the toilet, first of all, check the sewage pipe, check whether there is dirt, sand, waste paper and other debris in the pipe, and clean up around the nozzle. In addition, check whether the floor of the toilet seat is level. If the ground is uneven, it should be leveled before installation.

Second, align the outlet pipe of the toilet with the outlet pipe, then align it flat, mark the bolt holes of the toilet, and then remove the toilet.

Thirdly, drill a hole with a diameter of 20mm and a depth of 60mm at the mark, insert a bolt with a diameter of 10mm into the hole, screw it firmly with cement, then put the toilet seat on the bolt smoothly to make it match the mark, and then remove the toilet seat.

Fourth, put putty around the water outlet and sewer pipe of the toilet, then align the four bolt holes of the toilet with the bolts, and then straighten them. Remember to put a rubber pad on the bolts and screw on the nuts.

Fifth, aim at the center of the back end of the toilet, draw a vertical line, and draw a horizontal line at a height of about 800 mm from the ground. Mark horizontal lines according to the positions of the two side holes on the back of the water tank, drill a hole with a diameter of 30mm and a depth of 70mm at the standard hole, and then insert a bolt with a diameter of 10mm and a length of 100mm into the hole.

Sixth, hang the back water tank on the bolt and straighten it to ensure that it is aimed at the center of the toilet. Bolts should be padded with rubber pads and tightened with nuts.

Seventh, when installing the sewer elbow of the rear water tank, the nuts of the sewer outlet of the rear water tank and the water inlet of the toilet should be removed first and put on the sewer elbow respectively, and the sewer pipe should also be put on rubber pads respectively. Insert the upper end of the sewer elbow into the sewer of the rear water tank and the lower end into the water inlet of the toilet, then push the rubber pad to the water inlet and screw on the nut.

Eighth, when installing the water tank fittings, drain the water for 3-5min to flush the pipeline, then install the angle valve, connect the hose, connect the hose with the inlet valve of the installed water tank fittings, and then press the water supply.

Ninth, after the installation, debugging inspection should be carried out to check whether the inlet valve and seal are normal and whether the installation position of the drain valve is flexible. Once the problem is found, the cause should be found out immediately and repaired.

Tenth, after the toilet is installed, it cannot be put into use until the glass glue or cement slurry is completely cured. Generally, it cannot be used within three days after installation.

Whether the toilet is installed correctly or not directly affects the future use effect of residents. Once there is a problem, it is not only annoying, but also the maintenance process is more complicated. Therefore, the owner must not be careless when installing the toilet, and must strictly check the effect.