Baojun 560 Cleaning Throttle Operation

Baojun 3 10 can clean the throttle quickly by going to the 4S shop, but don't you have to go to the 4S shop every time you clean it? Actually, you don't have to. You can handle it yourself. Just don't forget to initialize.

When cleaning the throttle valve, first remove the intake throat to expose the throttle valve, remove the negative electrode of the battery, turn off the ignition switch, straighten the throttle plate, spray a small amount of "carburetor cleaner" into the throttle valve, and then carefully scrub it with a polyester rag or a high-spin "non-woven fabric". Deep in the throttle, you can hold a rag and scrub it carefully where your hands can't reach it.

After cleaning, the throttle will be initialized according to the disassembly procedure just now. After cleaning the throttle, it needs to be initialized, because the computer has a memory function when adjusting the throttle opening, because there was sludge blockage in the past. In order to ensure the air intake, the computer will automatically adjust the throttle opening to make the air intake in a normal state. But there is no sludge blockage after cleaning. If the throttle valve still maintains its previous opening, it will cause excessive intake air. As a result, the engine will shake when starting, and the acceleration will be weak, and the engine fault light may light up.

Then why does the engine sometimes work normally without initialization after cleaning the throttle? That's because the throttle is not too dirty, and its intake has not changed much after cleaning. However, the change of the throttle valve after cleaning is invisible to the naked eye and needs to be initialized. In fact, initialization is very simple. You can do it with a special computer or by hand, but it is not as fast as a computer, and sometimes it will fail. It doesn't matter if you fail. Do it again.