How to do the long balloon modeling course?

1. Inflate the long balloon with a pump and tie it for later use. Don't blow too full. Then, from the knotted part, twist out a small light bulb and hold it tightly.

2. Twist a small light bulb slightly larger than the first one, then twist a small light bulb slightly larger than the second one, and then twist a small light bulb slightly larger than the third one. The three bulbs twisted together in front must be pinched tightly, otherwise it will easily spread out.

Now we have four light bulbs, and then twist the fifth one. It should be noted here that the fifth light bulb should be as big as the third one, and then the sixth light bulb should be screwed to be the same as the second one; Twist the second twisted bulb with the tail of the balloon, and you will see a circle here.

4. Then turn the 1 th light bulb from the ring to the back, install the light bulb on the top of the ring by hand, and then screw the light bulbs on both sides together as the bear's ears.

5. Twist tightly when twisting, so that the bear face is formed; Turn the light bulb that has just been turned back from the bear's face and make it into a bear's nose.

6. Reserve a balloon about 3 cm below the bear, then use the reserved 3 cm to make the bear's bow, and screw the corresponding bow in the other 3 cm; In this way, the fat bear is finished. If there is an extra light bulb next to the bear's face, pinch it, cut it off and tie a knot.