What is the installation method of motorcycle throttle line?

The installation method of motorcycle throttle line is: 1. Passing the throttle pipe through the upper cover of the carburetor, putting the spring on the throttle pipe, then extending the throttle pipe out of the throttle hole, pulling it out of the next groove and winding it around the bottom, and releasing the head of the throttle pipe from the groove at the bottom of the throttle; 2. When installing the throttle valve into the carburetor, pay attention to that the inclined plane of the throttle valve is small, facing the idle screw, and the long slot is facing the bump in the carburetor, falling to the bottom, and then tighten the cover. Both lines of the motorcycle lead to the throttle handle on the right side of the handlebar. Above is the throttle line, which is responsible for controlling the throttle and oil needle, and on the side is the acceleration pump line. When the throttle turns sharply, the carburetor can spray a stream of oil to the throat, which improves the acceleration when accelerating sharply.