How to clean up the carbon deposit of KIA k3

Remove the air filter first, then the throttle valve, unscrew four screws, remove the throttle valve, then spray the cleaning agent and rinse it with water. The main cause of throttle scaling is oil and gas, followed by particles and moisture in the air.

Dongfeng Kia k3 throttle initialization, Kia k3 throttle matching method Dongfeng Kia k3 throttle does not need to be matched. After cleaning, the computer will automatically match the vehicle after a few minutes of normal idle speed.

One thing to note is that fuel consumption or idle speed will increase instability in a short time after cleaning, so don't struggle, just run for a while.

Because after the vehicle cleans the intake valve. Because the flap on the throttle still moves in the original way, the flap is not in place, but all kinds of carbon deposits have been cleaned up, so the air intake will be more than normal. So it will cause a slight increase in fuel consumption and idle speed.

There are two kinds of throttle: traditional cable throttle and electronic throttle. Kia K3 is the electronic throttle. The traditional engine throttle control mechanism works through a cable (soft steel wire) or a pull rod, one end of which is connected with the throttle pedal and the other end is connected with the throttle linkage plate. The electronic throttle mainly uses the throttle position sensor to control the throttle opening according to the energy required by the engine, so as to adjust the intake air.

How to remove the accelerator of Dongfeng Kia k3 and how to open the accelerator of Kia k3? The disassembly method of Dongfeng Kia k3 accelerator is relatively simple.

1. Unscrew the screw connecting the pipeline between the throttle valve and the air cleaner box and remove the pipeline.

2. Unplug the electric wire on the throttle.

First, apply a little oil on the fixed metal beam ring to avoid slipping teeth during disassembly. Remove the metal wire harness ring of the throttle hose. After the hose is removed, the left end is the position of the throttle. Remove the negative battery, turn off the ignition switch, straighten the throttle plate, spray a small amount of "carburetor cleaner" into the throttle, and then carefully scrub it with polyester rag or high-spin "non-woven fabric". Deep in the throttle, you can clamp the rag and scrub it carefully where you can't reach it.

When cleaning the throttle valve, it is not necessary to disassemble it, but the sealing part of the inlet steam must be cleaned, and the idle motor must be disassembled for cleaning. There are advantages and disadvantages of cleaning nozzles by borrowing and disassembling. Generally speaking, the maintenance station suggests disassembling and washing, which can prevent other unnecessary waste, such as replacing the sealing ring after disassembling or installing other gaskets, or delaying the owner's time because of oil and gas leakage when disassembling.

How to match the throttle of Dongfeng Kia k3 and how to reset the throttle of Kia k3. The throttle of Dongfeng Kia k3 does not need to match. After cleaning, the computer will automatically match the vehicle after a few minutes of normal idle speed.

One thing to note is that fuel consumption or idle speed will increase instability in a short time after cleaning, so don't struggle, just run for a while.

Because after the vehicle cleans the intake valve. Because the flap on the throttle still moves in the original way, the flap is not in place, but all kinds of carbon deposits have been cleaned up, so the air intake will be more than normal.