Which fuse is pulled by Toyota throttle matching method?

In Toyota's throttle matching method, EFI and ETCS fuses are pulled from the fuse box in the engine compartment. The information about the throttle is as follows: 1. Throttle: It is a controllable valve that controls air to enter the engine. There are two kinds of traditional cable and electronic throttle. 2, location: connected to the air filter, connected to the engine block, known as the throat of the car engine. The maintenance method of the throttle valve is as follows: 1. Bleeding: Oil will volatilize when used. The longer the use time, the higher the temperature and the stronger the volatilization. In addition, the compressed gas of the cylinder will squeeze into the crankcase through the gap of the piston ring, so there must be a channel to bleed or the oil bottom will form positive pressure. 2. Negative pressure pumping: The reason why the crankcase ventilation pipe is connected to the throttle valve is that on the one hand, it is an environmental requirement, and on the other hand, it uses the negative pressure of intake air to pump gas from the crankcase. When the oily steam gets cold after reaching the intake pipe, the oil in it will condense on the air inlet and throttle valve, and then the carbon deposit in the steam will also be deposited on these parts. Because the gap opened by the throttle valve has the largest air flow, small space and low gas temperature, this part is the easiest to condense. 3. Cleaning frequency: How long the throttle will be dirty depends on the quality of the air filter, the brand of oil used, the quality of the road, the temperature, the working temperature of the engine, driving habits and so on.