How to refit liquefied gas stove into natural gas stove

DIY changed liquefied gas stove into natural gas stove.

Sunset Red lbq transformed Vantage liquefied gas stove JZT-B3 17A into natural gas stove, which has been used for more than two years and achieved good results. Compared with the newly bought natural gas stove, it is no different from the blue flame. The specific transformation method is as follows, for your reference only.

This Vantage liquefied gas stove is a double-barrel stove, and each stove eye is divided into an outer ring fire and an inner ring fire. The aperture of the two nozzles is: the aperture of the outer ring nozzle is φφ= 0.92mm, and the aperture of the inner ring nozzle is φ = 0.42 mm. The aperture of the inner ring nozzle of the natural gas stove with the same model as this liquefied gas stove is φφ= 0.65mm, and the aperture of the outer ring nozzle is φ =1.35mm..

Knowing the aperture sizes of the two nozzles in the outer ring and the inner ring of the liquefied gas stove, and knowing the aperture sizes of the two nozzles in the outer ring and the inner ring of the natural gas stove, the idea of transforming the two nozzles in the liquefied gas stove into two nozzles in the natural gas stove is clear. Because of the high pressure of liquefied gas, the aperture of the nozzle is relatively small; The pressure of natural gas is small, so the aperture of the nozzle is relatively large. The outer ring nozzle of liquefied gas stove was expanded from 0.92mm to 1.35mm, and the inner ring nozzle aperture was expanded from 0.42mm to 0.65mm, thus transforming the liquefied gas stove into a natural gas stove. It's simple to say, but it's still complicated to operate. The specific transformation steps are briefly introduced as follows:

Turn off the liquefied gas source → remove the liquefied gas stove from the stove → open the panel of the liquefied gas stove, and you can see the internal structure of the liquefied gas stove → remove the four nozzles of the outer ring and the inner ring from the joint of the liquefied gas inlet pipe with a small wrench (two nozzles in one furnace hole and four nozzles in two furnace holes * * *) → hinge the nozzles of the outer ring to 1.3 mm (standard is 1.35mm) Hinge the inner ring nozzle to 0.7mm (0.65mm)→ standard time) → After the four nozzles of two stoves are hinged, wrap several circles of raw material tape around the connecting threads of the nozzles, put the four nozzles back in their original positions respectively, tighten them with a small wrench → check whether the new joint leaks with soapy water, and cover and fix the panel of the liquefied gas stove under the condition that the seal is airtight → connect natural gas for ignition test. When you see two stoves,