How to disassemble the panel of 20 10 Swift Heater?

20 10 Swift heating plate can be disassembled by sitting in the back row, and you will find three plastic cover plates under your legs. Take them off, and you will find that three screws are loose. There is a small depression above the back seat. You can touch it with your hand and press it again, and the back of the chair will be put down.

Use Swift heating panel

Then I moved into the trunk. At the junction of the back seat and the bottom of the car, I pulled over a little. I found a black nylon belt about 4 cm long and about 1 cm wide. I pulled it hard and the whole back seat could be turned over. Then I found a plastic cover in the back. I pulled it hard and found the screw. I can take the seat down after I release it.

Pull down the first two knobs to open them. The first two knobs are snap-type, so you should clamp them from the back and push them forward with needle-nosed pliers. Installation: Connect the zero line to the public zero line, and then connect the phase line to the lower ends of the three gear switches, which can be achieved.