How to remove the ball of the reversing light switch of cheetah car

1. Prepare a 24MM large cover plate to remove the reversing light switch, an 8MM plum blossom plate to remove two 8MM screws of the gas grid, and a cross knife. Remove the gas grid and throttle clamp, and remove the gas grid, one * * two 8mm screws and one clamping screw connecting the throttle body.

2. Remove the upper cover of the air chamber from the removed air chamber base, and pay attention to unplugging the plug of the flow sensor and removing the working face vacated by the air duct behind the air chamber.

3. When disassembling, pull out the wire harness first, and then take out the ball. When pulling out the wire harness by holding down the clip, loosen the backup light switch with a 24 mm sleeve plate, and be careful not to drop foreign objects into the hole.