Where is the Toyota Camry throttle fuse?

Generally, the fuse box of the Pacific car network is close to the battery. Fuse boxes are generally fixed with buckles, and some advanced models will be bolted. You need to open the box carefully to open the fuse. Throttle reset method: turn on the ignition switch, don't start the engine, wait for 10 second, then step on the throttle to the bottom and hold it for more than 15 second. After loosening, turn off the vehicle power supply and wait 15-20 seconds, then turn on the ignition switch, start the engine and reset the throttle.

Camry throttle reset needs to pull EFI fuse and throttle fuse. Camry's throttle reset method: turn on the ignition switch, don't start the engine, wait for 10 second, press the throttle and hold it for more than 15 second. After loosening, turn off the vehicle power supply and wait 15-20 seconds, then turn on the ignition switch, start the engine and reset the throttle.

The throttle reset mode can be reset in three ways: manual matching; Power failure matching; Diagnostic instrument matching.

1. Manual matching: some cars use cable throttle. After changing the throttle, it can be matched manually. If the key of the ignition switch is turned on and off for many times, the on-board computer will erase the memory of the crude oil door and store the data of the new throttle. When the vehicle hits and the vehicle runs normally, the matching is completed.

2. Power-off matching: After replacing the throttle, you can disconnect the negative electrode of the battery and wait for one minute before installation. In this process, the original memory of the on-board computer will be erased, the factory settings will be restored, and the vehicle will start to run normally and the matching will be successful. This method is only suitable for low-grade cars, not high-grade cars.

3. Diagnostic instrument matching: After changing the throttle, you can use the special diagnostic instrument for automobiles to match. After entering the system, select the action test and click the adaptive value reset to zero. This is done several times in a row, and the vehicle starts to run normally, indicating that the matching is successful.