How to remove the throttle of Chevrolet Mai Rui Bao?

Dismantling the throttle of Chevrolet Mai Rui Bao: Generally, the throttle is fixed with four screws, the upper two screws are easier to disassemble, and the lower screws are awkward. We suggest that the following two screws that are difficult to remove should be removed first, so as to avoid that the lower screw is difficult to remove because the upper screw has been removed and not fixed properly, which will lead to the shaking of the throttle. It is convenient to remove the screws by hand afterwards, but be careful that the screws fall into the engine room. After removing the four screws, you can remove the throttle, and the exposed pipe is the air inlet.

Maibao throttle matching: computer matching requires a 4S successful computer. If it is manual matching, disconnect the battery line 15 minutes. Throttle installation: The four screws for fixing the throttle can be screwed by hand first, because the hand is sensitive, so avoid screwing the screws directly with the sleeve, and then tighten them with tools after screwing them by hand. Then plug it in. It takes a little effort to install it. After Hear & amp ldquoDa & amprdquo is clicked once, the display is fixed.

After installing the throttle valve, you can install the hose. There will be two small grooves on both sides of the hose, one large and one small, which can be aligned with the large and small protrusions on both sides respectively. Both ends of the hose should be fully inserted. If it is difficult to install, you can screw it at the same time. After the concave and convex points at both ends are completely aligned, touch the bottom of the hose by hand to ensure that the bottom is completely inserted, and then tighten the screws on the clamp to install the engine trim cover.

Million car purchase subsidy