My Li Xia N5 battery is unstable at an idle speed of about 500 after replacing it with a new one. What is the flameout?

How is my Li Xia N5 battery idling about 500 after replacing it with a new one? How is my Li Xia N5 battery idling about 500 after replacing it with a new one? What is the cleaning at an idle speed of about 30 thousand kilometers? There are two ways to clean the throttle: one is not to disassemble or wash it. One is to remove it and clean it. Actually, it's about the same. The key is to look at the operation of the maintenance technician. Reminder: Because the computer has a memory function, it has adapted to the state before the throttle is cleaned. After the throttle is cleaned, the change of throttle opening (even slight) is directly transmitted to the computer, and there are two signals. Common phenomena are high and low idle speed or high idle speed, so it is recommended to use the detection computer to match after cleaning the throttle. It is normal that this happens just after replacing the battery, because the new battery needs a period of adaptation. But if this happens for a long time, be sure to take it and check it again. There may be some mistakes, which will be very dangerous at this time. It is best to carry out a learning program of throttle position sensor to restore the memory lost by computer due to power failure, so as to adapt it to the present situation of automobile and improve the overall performance. The method is as follows: 1. There should be a certain degree of freedom in overhauling the throttle cable. Idle speed is normal. Don't step on the accelerator and hit the steering wheel when performing the learning program. 2. Turn on the electrical switch, but don't start the engine. First enter the self-diagnosis procedure, then wait for 20 seconds and repeat this step for 3 times. 3. Start the engine 13 minutes or more, and keep the computer air conditioner control switch in the off position. @20 19