Traditional Culture Encyclopedia - The 24 Solar Terms - How to open the engine compartment of Lectra 03, Lectra 03 engine compartment cleaning tutorial.

How to open the engine compartment of Lectra 03, Lectra 03 engine compartment cleaning tutorial.

2022 Kline 03 Method of Opening Engine Cabin;

1. Find the switch of the engine cover in the cockpit, pull up the handle of the engine cover, and then the engine cover will open a gap;

2. Put your hand into the gap in front of the car and pull the safety switch to lift the engine compartment cover upward;

3. Open the safety buckle of the engine compartment cover, pull out the support rod of the engine compartment cover, and then put one side of the support rod into the support notch of the engine compartment cover to support the engine compartment cover. (If the vehicle is equipped with a hydraulic support, manual support is not required. )

As for closing the engine compartment, the steps are much simpler than opening the engine compartment. Hold the engine compartment cover by hand, take out the support rod and put it back in place. If it is hydraulic, this operation is unnecessary, and then slowly lower the engine compartment cover. Finally, as long as you put your hand on the hood, press it down slightly and hear the click of the safety button, you will close the engine compartment.

The process of cleaning the engine compartment of Link 03.

If the car has been driving for a while before preparing to clean the engine compartment, wait until the engine cools down before cleaning it to prevent the engine from overheating and causing burns.

1 Clean the dust and sundries visible to the naked eye on the surface.

Wipe off the dust and sundries on the surface with a brush first.

2 clean grease

Oil dirt is often produced during engine operation, which is difficult to clean after solidification. Spray special cleaning agents on all parts to completely soften and decompose the oil stains on the surface, and then wipe them with a wet cloth. For stubborn dirt, spray more cleaning agents and brush with a brush.

3 Rinse with water after cleaning.

Remember not to use high-pressure water gun when washing, because the water pressure is high when washing, which may easily cause electrical components to fall off or short circuit in water.

4 glass protection

After cleaning, dry all parts of the engine compartment, and then spray varnish for care.