How to match the throttle of Dongfeng Honda Ailishen?

After replacing the throttle valve, the negative battery is disconnected for a few minutes, and the vehicle goes to sleep. During this process, the original memory of the on-board computer will be restored to the factory settings. Then, reconnect the battery negative power cord and start the ignition test run until it is normal.

Throttle is a controllable valve, which controls air to enter the engine. After the gas enters the intake pipe, it will be mixed with gasoline to form a combustible mixture, which will be burned to do work. It connects the air filter and the engine block, and is called the throat of the automobile engine. Throttle installation: The four screws for fixing the throttle can be screwed by hand first, because the hand is sensitive, so avoid screwing the screws directly with the sleeve, and then tighten them with tools after screwing them by hand. Then plug in the plug, which needs a little force to install. After hearing the sound of "beating", the explanation is fixed. After installing the throttle valve, you can install the hose. There will be two small grooves on both sides of the hose, one large and one small, which can be aligned with the large and small protrusions on both sides respectively. Both ends of the hose should be fully inserted. If it is difficult to install, you can screw it at the same time. After the concave and convex points at both ends are completely aligned, touch the bottom of the hose by hand to ensure that the bottom is completely inserted, and then tighten the screws on the clamp to install the engine trim cover.

Million car purchase subsidy