Installation method of water heater connector

The first step in installing the water heater connector is to find a dry, ventilated and firm place to fix the water heater, and distinguish the functions of the three connectors below the water heater to prevent the wrong connection. The connection between water heater and water pipe should use special high-pressure pipe or special soft air pipe, and a pressure reducing valve should be installed between high-pressure pipe and air pipe. Finally, check whether there is water leakage after installation, and turn on the power supply to adjust the water temperature.

The specific operation method is as follows:

First, fix the water heater in a ventilated, safe and firm place outside the bathroom. There should be no flammable materials around, and keep a distance of more than one meter from the wires and trachea.

Distinguish the functions of the three connectors under the water heater. The leftmost connector is generally a hot water connector, the middle connector is a gas connector, and the right connector is a water inlet connector. Be sure to read the logo clearly, or you will be in big trouble if you connect it wrong.

The connection between water heater and water pipe should use special high-pressure pipe or special soft air pipe, and do not use hard pipe for direct connection.

A pressure reducing valve should be installed between the high-pressure pipe and the trachea to facilitate pressure adjustment and maintenance.

After installation, check whether there is water leakage or air leakage, and install the smoke exhaust pipe outdoors.

Finally, install the battery (usually 1 battery) or plug in the power supply, and then adjust the water temperature according to the weather conditions.

The answer is applicable to most brands of water heaters such as Wanhe, Midea and Haier.