How to replace converse reversing switch?

1. First, prepare a 24MM large cover plate to remove the reversing light switch, and an 8MM plum blossom plate to remove two 8MM grille screws. Cross tool change, remove air filter and throttle. Remove the air filter and connect the throttle body with one * * * two 8MM screws and one clamping screw.

2. Secondly, remove the air chamber cover removed from the air chamber base. After removing the gas box, pay attention to unplug the plug of the flow sensor and the working surface vacated by the air duct. Then, when removing the backup light switch, first pull out the wire harness. Pay attention to hold the clip and pull it up. When unplugging the wire harness, unscrew the backup light switch with a 24 mm socket plate. Be careful not to drop foreign objects into the hole.

4. Finally, connect the new backup light switch to the wiring harness, unscrew the switch without ignition, put it into reverse gear, press the telescopic switch of the backup light switch head, and a "beep" sound will appear, and the rear backup light will light up to indicate that the switch works normally. Turn off the switch, remove the wire harness, and install the switch assembly on the gearbox body.