How to clean the filter element of water purifier

Many families will buy water purifiers. I believe many friends have a worry about how to clean the filter element of water purifier. The following is the cleaning method of the filter element of the water purifier I collected, hoping to help you.

The cleaning method is divided into the following steps.

1. Separate the upper and lower sections of the filter element of the water purifier, open the bottom valve and clean the inside of the filter cartridge. Then rinse the filter element with clean tap water, and brush the surface of the filter element with an unused toothbrush.

2. Add about half a pot of tap water to the filter element above, shake the filter element of the water purifier up and down several times, and then pour out all the remaining water to make the micropores of the filter element unobstructed.

3. Fill the filter element of the next water purifier with tap water, pat the mouth with your hand to make it vibrate, then clean the filter material with tap water, and repeat it several times until the water flowing out of the next filter element is relatively clean.

4. When cleaning the cold and warm rooms, put clean water (not necessarily filled) in the upper container of the water dispenser, unscrew the drain plug, and catch the water flowing out of the drain hole with a basin, and repeat it several times.

5. Gently put the filter element into the filter cartridge, put away the gasket and flange cover, tighten the bolt, and finish cleaning.

After normal operation, according to the water quality, clean the filter element regularly according to the above procedures.

In addition, I tell you that the filter element of the water purifier should be washed for the first time, and the protective liquid in the water purifier should be washed off. The method is to open all tap water, tap water inlet ball valves and purification faucets, and rinse for 15 minutes until the produced water is clear and foam-free. Frequent switching of tap water during flushing (3 seconds off, 10 seconds on) will make the water flow pulse and make the flushing effect better. After that, turn off the sewage faucet and turn on the purification faucet. After 5 minutes, the water can be used normally.