Haval h6 throttle valve disassembly-free cleaning

The air inlet of Haval h6 is equal to the human respiratory tract, and the air battery can't worry about all the dust. _ Over time, the throttle will feel less sensitive to the oil dirt generated by dust, and at the same time, the oil dirt will block the waiting safety passage and the environmental pollution waiting valve, endangering the driving force of the engine and speeding up the function and fuel consumption. The example tutorial of disassembly-free cleaning of throttle valve is as follows:

1. Put a cotton towel under the throttle to prevent the throttle cleaning fluid from flowing around. Spray the electronic throttle cleaner on the throttle surface, and wait for 3 minutes after filming, so that the liquid can fully dissolve the carbon deposit;

2. Because the throttle valve is an electronic device throttle valve, you have to enter the car at this time, turn the key, plug in the power supply, and don't start it. Ask a friend to help you step on the gas pedal. Then aim at the end face of the throttle and the shaft for gushing cleaning, and wipe the empty cleaning agent with a rag at the same time;

3. Run the engine at this time. At this time, it is very likely that it will not be easy to start, and you can bring some accelerator pedals to prevent ignition. Then increase the engine speed ratio to 1200~2000r/min, and clean the inner wall of the throttle (pay attention to the engine speed ratio);

4. Turn off the car and turn off the engine; Restore the throttle connecting pipe to normal, restart the engine, accelerate for 2~3 times after 3 ~ 5 minutes, and control the speed ratio at 3000r/min.

Finally, if everything is normal, the fault code can be eliminated without disassembling the throttle. If some students have a fault code after cleaning, they can unplug the negative line of the battery for 30 seconds at the same time, and then connect it without going to the 4S shop.

Million car purchase subsidy