Traditional Culture Encyclopedia - The 24 Solar Terms - Can the computer detect the cylinder pressure?
Can the computer detect the cylinder pressure?
Extended data:
The detection method of cylinder pressure is carried out according to the following steps. Step 1: Install the cylinder pressure gauge on the engine.
The second part: warm the car first, let the engine run to normal temperature, and keep the temperature of coolant between 85-95 degrees.
Step 3: Remove all spark plugs or fuel injectors on the vehicle and ground the high voltage line.
Step 4: Step on the gas pedal and let the gas pedal fully open.
Step 5: Screw the threaded pipe joint on the spark plug hole. The conical rubber joint of the cylinder pressure gauge can also be pressed into the spark plug hole of the cylinder to be tested.
Step 6: Start the starter for about two seconds. After the pointer is determined, read the pressure value, and then press the check valve (check valve) button to exhaust and decompress, so that the pointer returns.
In this method, it should be noted that the number of measurements per cylinder is not less than two times, and the average value is the best.
In addition, during the second measurement, a little oil can be injected from the spark plug hole, and then the cylinder pressure can be measured. The amount of oil injected is 20~30ML.
If the cylinder compression pressure is the same as before fuel injection, the valve leakage can be judged.
- Related articles
- Twenty-four solar terms correspondence table
- When is Manjusri Bodhisattva Christmas?
- Function of Chevrolet copaci aps button
- How often does the eighth generation Camry clean the throttle?
- What did the ancients do in the cold season?
- Solar terms in ancient chronological methods
- Introduction to the 24 solar terms in summer: What does summer mean?
- Where is the car oxygen sensor?
- Innate gossip and other strange teachers told me. I want to join this novel.
- Summer solstice solar terms education cartoon