How to remove the fuel injector? Introduction of fuel injector disassembly steps

The nozzle needs to be cleaned regularly, but it is also prone to failure. After a fault occurs, it is necessary to remove the old one and replace it with a new one. So, how to remove the nozzle? Let us share with you the steps to remove the fuel injector. Introduction of fuel injector disassembly procedure: apply voltage to remove the fuel rail, remove the fuel injector, clean the carbon deposit at the inlet and outlet of the fuel injector with carburetor cleaner, then apply voltage of 12V to the fuel injector, and connect the carburetor cleaner thin tube to the inlet of the fuel injector. If it is too small, it can be thickened with black tape. One person can hold it with both hands to ensure that the carburetor cleaner and the injector inlet do not leak oil, and the other person can tap the 12V power supply to let the cleaner spray intermittently until the oil mist sprayed by the injector is small and uniform. Instructions for fuel injector disassembly procedure: Pay attention to the installation of rubber sealing ring of fuel injector to avoid aging and defects. Uncleaned injector oil mist is like rain, and cleaned injector oil mist is like fog. After installing the injector, observe whether the upper and lower sealing rings of the injector leak oil, and no gasoline can leak. At the end of the introduction, the steps of removing the fuel injector are very simple, only two steps are needed. I hope the loan number can help you, remember the steps, clean them up regularly and avoid failure.