Does the flexibility of car acceleration have anything to do with the throttle?

Whether the acceleration of a car is flexible is closely related to the cleanliness of the throttle. The most accurate way to judge that the throttle is broken is to check the throttle with a scan tool and observe the data flow. If the throttle opening is large, it must be cleaned. If it is determined that the fault of the throttle valve is permanent, it must be replaced. Generally, the throttle cannot be disassembled for maintenance, only the assembly can be replaced.

It is necessary to clean the throttle, because whether the speed of the car is flexible or not is closely related to the cleanliness of the throttle. Cleaning the throttle can even improve efficiency and save fuel # Throttle #

There are several possibilities for forced throttling:

1, throttle oil pressure is too high or too low. There was an accident, the airbag exploded and the throttle stuck. In this case, just clear the fault code. 3. Throttle motor failure.

Because I have never seen a real car, I can't make an accurate judgment. I need the owner to go to a 4S shop or a professional garage, and let the mechanic read the fault code with a code reader, determine the problem, and then repair it. Generally speaking, if there is no problem with acceleration, the idle speed can be ignored without jitter.

Brief introduction of additional throttle:

Throttle is a controllable valve that controls air to enter the engine. After the air enters the intake pipe, it will be mixed with gasoline to form a combustible mixture, and the combustion is successful. It connects the air filter and the engine block, and is called the throat of the automobile engine.

Whether the acceleration of a car is flexible or not has a lot to do with the dirt of the throttle. Cleaning the throttle can reduce fuel consumption and make the engine flexible and powerful.

Throttle matching method

The first thing to know is that the cable throttle does not need to match, and the electronic throttle needs to match.

1. After replacing the throttle, disconnect the negative battery for a few minutes, and the vehicle will go into hibernation. During this process, the original memory of the on-board computer will be restored to the factory settings. Then reconnect the battery negative power cord, ignition test run, and it will be normal.

2. If you have the 5053 data cable at hand, the method is as follows: VCDS 10.6.3 software, enter the "Engine" module, enter "Match", enter "000" in the channel number, and then click OK (the purpose of this is to clear the memory data of the original ECU about the throttle).

Return to "Basic Settings", enter "060" in the channel number, and click "OK". The data displayed on the right will complete the throttle matching.