Jeep guide gas pedal maintenance

The disassembly method of the pilot throttle valve is as follows: 1. Remove the air inlet pipe and empty filter box connector and pliers. 2. Remove the crankshaft ventilation pipe T20. Open the empty filter box and break it by hand, then you can clean the upper part of the throttle valve. If you want to clean it thoroughly, please remove four screws to remove the throttle valve. Installation: 1. The four screws used to fix the throttle can be tightened by hand first. Because the hand is sensitive, avoid screwing the screw directly with the sleeve. After tightening by hand, they can be fixed firmly with tools. Then plug in the plug, which needs a little force to install. After hearing the sound of "beating", the explanation is fixed. 2. After installing the throttle valve, you can install the hose. There will be two small grooves on both sides of the hose, one large and one small, which can be aligned with the raised marks on both sides respectively. Both ends of the hose should be fully inserted. If it is difficult to install, you can screw it at the same time. 3. After the concave and convex points at both ends are completely aligned, touch the bottom of the hose with your hands to ensure that the lower part is completely inserted, tighten the screws on the iron hoop, install the engine decorative cover plate, and the cleaning work is completely completed. The matching method of the pilot throttle is as follows: according to the prompt, open the key (don't start the car), the computer prompts, press the accelerator pedal, 65432 1, release the accelerator pedal (don't release the accelerator pedal at this time), 65432 1, release the accelerator pedal (release the accelerator pedal at this time), and several lights on the instrument flash several times.