Does the installation of Huatai New Santa Fe Body Control Module need matching data?

The specific collocation method is as follows.

After entering the car, close the door until the dome light goes out, turn on the ignition switch, and the instrument light will come on. Press the rear defrost switch for 2-4 times quickly, and the dome light will come on. Press any key of the remote controller twice within 5 seconds when this light is on, and the matching is over.

Preparation conditions of China automobile anti-theft eliminator: key with chip and 4-digit electronic password. Method: (1) turn on the computer and wait for 4 seconds; (2) Step on the gas pedal until it is fully open, and the light goes out; (3) Release the throttle until it is closed; (4) According to the first password, the times of stepping on the accelerator are the same as the first password; (5) Repeat steps (2) to (4) to input the second to fourth passwords; (6) Step on the accelerator until the light is on; Release the throttle light and it will flash, and then the anti-theft will be lifted! If the engine anti-theft system itself fails, the electronic code on the emergency start card should be used to start the vehicle. Users must keep the emergency card and remember the electronic code on the card. Emergency starting method: turn the key from "LOCK" to "on"-wait for about 8 seconds-press the accelerator pedal and wait for the engine failure indicator to go out-(the number of times of pressing the accelerator pedal is equal to the first digit of the electronic code)-press the accelerator pedal and wait for the engine failure indicator to light up-(the number of times of pressing the accelerator pedal is equal to the second digit of the electronic code)-press the accelerator pedal and wait. Pay attention to the rhythm of stepping on the accelerator, and don't hurry up and down. If there is an error in the process, turn the key to the "locked" position and start again.