How to clean the throttle of Ruifeng s3 and how to clean the throttle of Ruifeng s3.

Ruifeng s3' s cleaning method for removing the accelerator: first remove the engine guard plate with 10mm sleeve, and then remove the engine guard plate with 10mm sleeve. Remove the air intake plastic pipe. Pry open the middle of the plastic clip with a screwdriver, gently pull out and remove the air inlet. Then remove the pipe from the intake hose and loosen the screw near the throttle clamp with an 8 mm sleeve. Then loosen the screw at the other end and remove the air inlet hose between the air cleaner and the throttle. It's just a hose. It can be removed with a little force. Remove the rubber hose of the char solenoid valve, clamp the clamp with pliers, and then pull it off. When the hose is removed in this way, the other two pipes of the throttle valve are also removed. Be careful that the water pipe will drip a little, so remove the throttle valve. Then use an 8mm sleeve, which is much more convenient. Otherwise, it will cost a lot of things. The throttle is completely removed and it is still dirty. At this time, be careful not to unplug the connecting plug with the throttle valve, and keep the connecting wire firmly in contact with the throttle valve during the whole cleaning process. The whole throttle is removed, and it's still dirty. Be careful not to unplug the connecting plug of the throttle at this time. During the whole cleaning process, keep the connecting pipe in close contact with the throttle valve. This is a 3M accelerator (door) cleaner. It is best not to use carburetor cleaner. Adjust the movable trigger, change the direction of ratchet wrench, install throttle and connect all pipes. Be careful not to connect the upper and lower pipes of the throttle valve in the wrong way. After cleaning and installation, the pipeline has been connected.