Traditional Culture Encyclopedia - The 24 Solar Terms - How to repair the Great Wall H5 engine if it doesn't catch fire?
How to repair the Great Wall H5 engine if it doesn't catch fire?
Steps:
1. Shut down both vehicles until the jumper cable is enough to connect the positive and negative poles of the two batteries. Care should be taken to ensure that the two vehicles are not in contact, and only cables with sufficient bearing capacity and insulating sheath are allowed. If the installation position of the battery providing power supply on the vehicle is not convenient for direct bridge, the battery must be removed with tools.
2. Determine the positive pole (+) and negative pole (-) of two storage batteries, and connect the positive pole and the positive pole and the negative pole with cables respectively. Pay attention to the positive and negative poles of the battery to ensure reliable cable connection. Adjust the direction of the cable to prevent the cable from scratching the tape or fan when starting.
3. Turn off all auxiliary electrical equipment on the vehicle, start the vehicle where the battery providing power is located, and let the engine run for a few minutes to ensure sufficient power. Then start the vehicle in a normal way without electricity. After starting, lightly step on the accelerator pedal and let the engine run at 2000 rpm for several minutes.
4. Turn off the ignition switches of the two cars, carefully remove the cables, and pay attention to avoid the collision between the positive and negative cable joints.
Solution 2: The cart starts.
Steps:
1, pay attention to safety first. Observe whether the road conditions at the parking position are suitable for the cart to start. For example, you can speed up by going downhill. If the front of the car is uphill, the cart will be very tired and it will be difficult to increase the speed, so turn the front of the car and push the cart downhill. Try not to start the cart on the road with many vehicles and pedestrians, so as to avoid accidents caused by improper driver response after the vehicle starts.
2. Turn on the ignition switch before pushing the vehicle. After reaching a certain speed, put the transmission into 2nd gear, and then quickly release the clutch pedal to refuel. Once the engine starts, you should quickly step on the clutch pedal and control the throttle to prevent the engine from stalling, and then slowly stop.
- Previous article:What is the year of Shuangchun?
- Next article:Twenty-four solar terms: beginning of autumn
- Related articles
- Low-carbon environmental speech
- Online Design of Wenchuang Products ¡ª¡ª How to plan and design Wenchuang products?
- Jiaozhou Tianjie Spring Festival Business Schedule
- How many days after the slight cold is it from slight cold to severe cold?
- Synonyms of solar terms What are synonyms of solar terms?
- The deepest solar term
- How to use air mattress to prevent bedsore in medical air cushion bed?
- Li Hong's Chrysanthemum Poems
- What is the impact of BMW m3 throttle regulator failure?
- How does the wife package jiaozi to praise them?