Audi A6 CVT matching method! ! Ask the master for help! Brother, thank you in advance! ! I used X43 1. .

After hot start, when the oil temperature reaches above 60 degrees, make sure that there is no fault code between the engine and the gearbox system, turn the ignition key to the on position, first make an engine 060 throttle match, then make a 063 forced downshift match, and then enter the gearbox system. Take the X43 1 testing computer as an example, enter the channel number to match, enter 000 to confirm, clear the adaptive learning value, and then carry out the drive test matching. D gear: Enter D gear, press and hold the brake 10S, release the brake and slide forward for about 20m; R gear: directly shift from D gear to R gear, hold 10S, then release the brake and slide backwards for about 20m. Repeat this several times, then drive at a high speed of about 20 kilometers, and observe whether the data stream group 10, 1 1 prompts "adaptive normal". If so, it means that the matching is successful, if not, repeat the above test until it is successful. This matching method can solve the problems of delay in entering D gear and impact in entering R gear, but the premise is that there is no pressure relief inside the wave box.