Changan cs95 how to remove the throttle, changan cs95 how to clean the throttle.

Changan cs95, how to remove the throttle? Cleaning method: first remove the engine cover with 10mm sleeve, and then remove the engine cover with 10mm sleeve. Remove the air intake plastic pipe. Pry open the middle of the plastic clip with a screwdriver, gently pull out and remove the air inlet. Then remove the pipe from the intake hose and loosen the screw near the throttle clamp with an 8 mm sleeve.

Then loosen the screw at the other end and remove the air inlet hose between the air cleaner and the throttle valve, which can be removed with a little force. Remove the rubber hose of the char solenoid valve, clamp the clamp with pliers, and then pull it off. When the hose is removed in this way, the other two pipes of the throttle valve are also removed. Be careful that the water pipe will drip a little, so remove the throttle valve.

The key tool came out (ratchet wrench) and used an 8mm sleeve, which was much more convenient. Otherwise, it will take a lot of work, and the throttle will still be dirty if it is completely removed. At this time, be careful not to unplug the connecting plug with the throttle valve, and keep the connecting wire firmly in contact with the throttle valve during the whole cleaning process. The whole throttle is removed, and it's still dirty.

Be careful not to unplug the connecting plug of the throttle at this time. During the whole cleaning process, keep the connecting pipe in close contact with the throttle valve. This is a 3M accelerator (door) cleaner. It is best not to use carburetor cleaner. Adjust the movable trigger, change the direction of ratchet wrench, install throttle and connect all pipes. Be careful not to connect the upper and lower pipes of the throttle valve in the wrong way. After cleaning and installation, the pipeline has been connected.