Do the throttle and injector need to be cleaned regularly? How to clean it?

The throttle and fuel nozzle need to be cleaned regularly. Fuel injector is the key component of engine, and its working performance will affect the use of engine. If the nozzle is blocked, it will affect the service life of the car, and some problems will occur during use. Nozzle blockage is mainly caused by engine carbon deposition. Gasoline will produce some impurities in the combustion process, which will accumulate on the throttle and nozzle over time, so it should be cleaned up in time.

If the owner does not pay attention in time, some impurities in gasoline will react at high temperature to form some sticky substances, which will become difficult to handle. If these carbon deposits always exist in the car, there will be a state of low speed or idle speed, which will aggravate the generation of carbon deposits. People need to judge whether it is necessary to clean up according to fuel quality and vehicle condition. The average car owner needs to clean the throttle and throttle after driving for 20 ~ 30 thousand kilometers, and the car with good quality can be a little later.

If people want to clean the throttle valve, they need to prepare relevant tools first and unplug the ventilation pipe of the crankcase. When removing the throttle, you can loosen the screw as much as possible, you can buy relevant cleaning agents to clean it, or you can prepare a pack of cotton swabs dipped in water. During the cleaning process, the air inlet hose outside the throttle should be removed first. You can use a tool to step on the accelerator, or you can ask someone for help. You can't disassemble it blindly, otherwise it will bring different degrees of damage to the car.

People can't disassemble the throttle valve by violent means, otherwise it will damage some accessories in the car. It must be done step by step, not in haste. The choke must be cleaned regularly. If it is not cleaned for a long time, it will have a bad influence and cause trouble in the cleaning process. It takes about 30 minutes for people to clean the fuel nozzle. After cleaning, they need to install the oil circuit of the original car. They can step on the accelerator several times with their feet. They need to buy the right reagents, but they can't buy some fake products.