Does JAC He Yue need computer matching to clean the throttle?

When cleaning, it is necessary to match, in fact, because the signal interface is unplugged, so the fault code must be eliminated.

Correct computer matching method after cleaning throttle and intake pipe;

1, after cleaning and installation, start the car to the hot car state (regardless of idle speed), and turn off the engine when the water thermometer is greater than 3 grids;

2. Insert intelligent key into the key slot. Don't turn on the switch. Open the fuse box. First remove the ETCS 10A fuse, and then remove the EFI25A fuse. After 30 seconds, install two fuses in the first-come-first-served order.

3. Start the engine normally within 1 min. Never turn on the switch or start the engine, which will easily cause the traction light and airbag light to light up; If this happens, please turn off the engine, turn off all switches on the vehicle, take out the negative battery for more than 30 seconds before installation, start the engine 1 min, then turn off the engine and repeat the above 123.