How long can the engine oil run without overhaul?

If the engine oil of Pacific Auto Network is not overhauled, it can continue to be opened. However, if the oil burns badly, it is recommended to maintain it. On the one hand, it can save oil, on the other hand, it can protect parts. The repair of automobile oil can be judged according to the degree of oil combustion.

Always open. When burning engine oil, if there is enough engine oil in the car, it can generally be turned on. However, if the degree of burning oil is large, it is recommended to maintain it, on the one hand, it can save fuel; On the other hand, it can protect parts, and the repair of automobile oil can be judged according to the degree of oil combustion. The oil consumption of normal engine oil is generally below 0.5L/ 1000 km. If it exceeds this value, it needs maintenance.

The solution to burning engine oil is basically to repair the engine, clean up the carbon deposit in the engine and replace the damaged parts, such as removing the engine cover and replacing the valve oil seal. If it is serious, the engine needs to be overhauled, so the phenomenon of burning engine oil cannot be ignored and should be dealt with in time.

Maintenance precautions Cleaning the air filter is directly related to the air intake problem of the engine when the car is driving. The manager of Guangben dealership told the reporter that the air filter will not be blocked when the car is only driving in the urban area, but if the car is driving on dusty roads, it is necessary to pay special attention to the cleanliness of the air filter.

If the air filter is blocked or there is too much dust, the air inlet of the engine will be blocked, and a large amount of dust will enter the cylinder, which will accelerate the carbon deposition speed of the cylinder, which will hinder the ignition of the engine and cause insufficient power, and the fuel consumption of the vehicle will naturally increase. If you drive on an ordinary city road.

Check the air filter when the car travels 5000 kilometers. If there is too much dust on the filter, consider using compressed air to blow the dust out of the filter element. But the pressure of compressed air should not be too high to avoid damaging the filter paper. He told reporters that water or oil must not be used when cleaning the air filter to prevent oil and water from soaking the filter element.

There are many reasons for fouling at the throttle, some of which are carbon deposits formed by exhaust gas from fuel combustion at the throttle; Then, impurities that are not filtered by the air cleaner will remain on the throttle. Too much sludge will cause air resistance and increase fuel consumption.

He said that the car should clean the throttle when driving 10000 to 20000 kilometers. When cleaning the throttle, first remove the intake throat to expose the throttle, remove the negative electrode of the battery, and turn off the ignition switch.

Straighten the throttle plate, spray a small amount of "carburetor cleaner" into the throttle, and then carefully scrub it with polyester rag or high-spin "non-woven fabric". Deep in the throttle, you can hold the rag and scrub it carefully where your hands can't reach it. After cleaning, install the intake pipe and the negative electrode of the battery, and you can ignite.

(Photo/Text/Photo: Pacific Auto Network Q&A called Beast)