Processing method of Jianghuai Shuailing lost foam casting car lamp

Processing method of jianghuai shuailing epc lamp. After the epc light of JAC Shuailing lights up, the treatment method is as follows: start to troubleshoot the air intake system, clean up the carbon deposit at the throttle and other positions, and then rewrite the relevant ECU data.

There are many reasons for this failure when the EPC light of the vehicle is on. Let's see:

1. air intake system failure:

If the air intake pipe leaks or is blocked, it will affect the engine's insufficient air intake, and the sensor of the vehicle will sense it, thus affecting the lighting of the epc light of the vehicle.

2. Throttle blockage:

If the throttle of the vehicle is too dirty or too much carbon is deposited, the air intake of the vehicle will be unstable, which will also affect the lighting of the epc light of the vehicle.

3. The fuel used is not up to standard:

The compression ratio of each vehicle engine is different, and the required fuel grade is not necessarily the same. If the gasoline used is lower than the required grade or the quality of the gasoline used is poor, the EPC light of the vehicle will also be affected.

4. Abnormal cylinder pressure:

In the cylinder of the engine, the working pressure is within the necessary range. If it is beyond the normal range, the epc light of the vehicle will light up.

5.ECU itself is out of order:

If the ECU hardware of the vehicle fails, the EPC light of the vehicle will definitely light up.

Bian Xiao's introduction ends here. After reading these introductions, do you have a certain understanding of the lighting treatment methods of Jianghuai Shuailing epc? I hope Bian Xiao's introduction can help you. You can go to other pages of this website to continue reading. Thanks for your support.