How to disassemble the throttle of Nissan Tiida and how to clean the throttle of Tiida.

How to disassemble and clean the throttle valve of Nissan Tiida: firstly, remove the engine guard plate with the sleeve of 10 mm, and then remove the engine guard plate with the sleeve of 10mm ... and remove the plastic pipe of the intake duct. Lever up the middle of the plastic clip with a screwdriver, gently pull it out, and then remove the air inlet. Then remove the pipe from the intake hose and loosen the screw near the throttle clamp with an 8 mm sleeve. Loosen the screw at the other end, and remove the air inlet hose between the air cleaner and the throttle valve, which can be removed with a little force. Remove the hose of the carbon charging solenoid valve, and clamp it with pliers to remove it. Remove the hose in this way, and the other two pipes of the throttle valve are also removed. Note that the water pipe will drop a little water, and remove the throttle valve. The key tool (ratchet wrench) came out, and the same 8mm sleeve was used, which was much more convenient. Otherwise, it would take a lot of effort, and the throttle valve was completely dismantled and still dirty. Be careful not to unplug the plug connected to the throttle valve at this time, and keep the connecting wire firmly in contact with the throttle valve during the whole cleaning process. The throttle is all removed, and it's still dirty. Be careful not to unplug the plug connected to the throttle valve at this time, and keep the connecting wire firmly in contact with the throttle valve during the whole cleaning process. This is a 3M throttle (door) cleaner. It is best not to use carburetor cleaner. Adjust the movable trigger, change the direction of ratchet wrench, install throttle and connect all pipes. Be careful not to connect the upper and lower throttle pipes by mistake. This means that the pipes have been connected after cleaning and installation. @20 19