How to match sagitar throttle

Pacific auto network 1. When the ignition switch is turned on, the throttle control unit and the engine control unit can adapt. 2, the basic setting of the throttle. 3 connect X-43 1 decoder. 4. Select "Normal Mode"-"Fast Data Flow Diagnosis Mode"-"Engine System", select "System Basic Adjustment" function, and enter the adjustment group number. 5. Press the "OK" key to enter the setting process. 6. Start automatic matching.

Note: The throttle adjustment matching is only applicable to Volkswagen equipped with electronic throttle engine system, and Santana GLi is not included in the matching range; The throttle adjustment matching channel number of Jetta's two-valve engine system is 060, and the five-valve engine system is 098.

1. Basic setting: When the ignition switch is turned on, the throttle control unit and the engine control unit can adapt themselves.

2. Basic setting process: During the basic setting process of the throttle, the throttle regulator moves from the maximum position to the minimum position during emergency operation, and the engine control unit learns the dead center position of the throttle control unit and the comparison curve between the throttle potentiometer and the throttle controller sensor through self-adaptation.

3. Dependence must be adaptive: ● Power interruption ● Remove throttle control unit ● Replace throttle control unit ● Replace engine ● Replace engine control unit.

4. Basic setting conditions: ● There is no fault in the fault memory ● The battery voltage is not lower than 1 1.5V● All accessories are closed ● The throttle should be in the idle position.

5. Basic setting methods and steps:

1) Turn on the ignition switch to start the engine.

2) Connect the X-43 1 decoder, and select the diagnostic programs of Shanghai Volkswagen, FAW-Volkswagen or German Volkswagen (note: the functions of the three softwares matching the throttle are the same, and any one can be operated).

3) Select Normal Mode-Fast Data Flow Diagnosis Mode-Engine System, select System Basic Adjustment function, and enter the adjustment group number: 098 or 060 or 00 1. The common throttle matching channel number is 00 1. Little red flag 48.

8. Passat B.

4. Audi (100,200, V6 and other old models) 098 Santana Gsi, Passat B5( 1.

8), Jetta King (5 valves), Audi (A6, V).

6)060 Jetta Pioneer (2 valves), A6( 1.8, 1.8T, 2.4, 2.

8), Passat B5 (1.8t,2.

8), Bora, POLO

4) Press the "OK" key to enter the setting process, and the throttle controller passes through the minimum to maximum point and the middle five positions. The control unit stores the corresponding throttle angle in the memory, which takes about 10 seconds, and then the throttle is in the initial position for a short time, and then closed.