Do you want to match the old POLO after cleaning the throttle?

After cleaning the throttle valve, POLO must match it, that is, initialize the driving computer, otherwise the effect of cleaning the throttle valve will not come out, and it may also cause certain consequences.

1. If there is too much sludge in the throttle, it may cause poor engine acceleration and increase fuel consumption, so it is necessary to clean the throttle;

2. When cleaning the throttle valve, first remove the intake throat, expose the throttle valve, remove the negative electrode of the battery, turn off the ignition switch, straighten the throttle plate, spray a small amount of "carburetor cleaner" into the throttle valve, and then carefully scrub it with a polyester rag or a high-spin "non-woven fabric". Deep in the throttle, you can hold the rag and scrub it carefully where your hands can't reach it. After cleaning, install according to the procedure just removed;

3. After cleaning the throttle, it needs to be initialized, because the computer has a memory function when adjusting the throttle opening, because there was sludge blockage in the past, in order to ensure air intake, the computer will automatically adjust the throttle opening to make the air intake in a normal state. But there is no sludge blockage after cleaning. If the throttle valve still maintains its previous opening, it will cause excessive intake air. As a result, the engine will shake when starting, and the acceleration will be weak, and the engine fault light may light up.