Traditional Culture Encyclopedia - The 24 Solar Terms - Teach you how to clean the accelerator and walk for Fox yourself.

Teach you how to clean the accelerator and walk for Fox yourself.

First, prepare the tools needed to clean the throttle, such as 7MM extended socket wrench, 8MM extended socket wrench (please replace the 8MM socket with a Torx T30 wrench due to the different displacement of throttle bolt 1.6), 10MM socket wrench, screwdriver (short), cotton swab, towel, throttle cleaner, etc.

1, open the cover (pull the cab)

2,2.0 has a cover, and we unscrew it with a sleeve of 10MM.

Insert10mm socket wrench.

Nut removal

Because I installed the upper pull rod, the cover plate can't be taken out, but it doesn't matter.

3. Open the empty filter box and use a 7 mm extended socket wrench. The screw is in the circle.

The top one

Yes, by the way, open the fuse housing and remove the air filter.

4. Pull off the inspection plug on the pipeline between the throttle valve and the air cleaner. Press the blue button in the red circle on the left, and there is a buckle on the right, which will be released when you pull it.

It's loose

5. Loosen the screws on the two locking belts on the pipeline with a short screwdriver.

Swing left and right to take out the pipe.

The throttle is displayed.

After washing 8000KM, shift gears 4000 times a day, and if nothing happens, turn the throttle 7000 times. Take a close-up.

6. Loosen the throttle control harness. Pull the red shrapnel with your nails in the direction shown in the figure and loosen the locking mechanism.

7. Loosen the throttle fixing bolt with an 8MM extended socket wrench (the throttle fixing bolt with the displacement of 1.6 is T30 Torx head, please use the corresponding tool).

Carefully remove the throttle.

Close-up of back

Pay attention to the blue sealing ring on the pipeline and cover it with plastic wrap to prevent dust from entering.

8. Clean the inside of the throttle with throttle cleaner, cotton swab and clean towel. (Cleaning step: spray the inside of the throttle valve at a 45-degree angle, scrub the flip structure of the throttle valve with a cotton swab stained with detergent, and finally finish it with a clean towel. Don't eat, don't spray on your eyes, don't spray on plastic parts. If there is no operation, please use clean water as soon as possible. )

The bottle body instruction is a disassembly-free cleaning method of a brand cleaning agent.

9. The throttle valve has been cleaned. Restore by reverse assembly. Please tighten the throttle fixing bolts crosswise.

10, after all the installation is resumed, start the car, directly start the throttle a few times without computer connection and matching, and then idle down later. Factory exhaust is still ok, listen to the effect.

ACC file, no alarm

light the fire