Installation method of Honda 100 motorcycle throttle line

Installation method of Honda 100 motorcycle throttle line.

1. Put the throttle cable through the carburetor upper cover, put the spring on the throttle cable, then put the throttle cable through the throttle hole, pull it out of the next groove and pull it to the bottom, and put the throttle cable head into the groove at the bottom of the throttle.

2. When installing the throttle valve on the carburetor, pay attention to that the throttle valve has a small inclined plane, while facing the idle screw, the long groove descends to the bottom, while facing the protrusion on the carburetor, and then tighten the cover.

3. Two lines of motorcycle lead to the throttle handle on the right side of handlebar. At the top is the throttle tube, which is responsible for controlling the throttle and oil needle. Next to it is the acceleration pump pipeline. When the throttle is tightened sharply, the carburetor can spray a stream of oil to the throat, thus improving the acceleration when accelerating rapidly.