Balloon modeling course is the simplest and most beautiful.

The steps of balloon modeling are as follows:

Material preparation: reflective glue, brushes, balloons and plastic balloon sticks, transparent tape, tin cartons, green cotton thread, battery lights, pencils, hot glue guns, green cardboard, cotton paper (pink, red and yellow), scissors and craft knives.

1. Fill the balloon with air and put it in an iron box to prevent it from rolling.

2. Cut the pink tissue paper into 2.5CM strips and stick it on the balloon with reflective adhesive for at least three layers. Repeat this step and stick all the balloons with cotton paper.

3. Punch a hole in the balloon with a craft knife, and cut a small circle in the lower half of the balloon, which is slightly smaller than the battery lamp.

4. Then, cut a seed-shaped hole in the tissue paper with a craft knife.

5. Apply a thin layer of reflective glue around each hole in the sphere, and then stick a small piece of yellow tissue paper.

6. Cut about five leaves from the green card paper, fold them slightly, and fix the plastic balloon stick and the battery lamp together.

7. Stick the leaves on the plastic balloon stick with a small amount of hot melt adhesive.

8. Fix the strawberry lantern with a green cotton rope, and it is finished.