18 what is the reason for the buzzing of the Bora flat throttle?

18 Borasson's throttle is buzzing. Cause: 1, the engine oil is not fully lubricated to all parts of the engine; 2. Clean the inside of the engine and enlarge the wear gap; 3, the gap is large and the seal is not good, and the engine condition will become worse; 4. Too much carbon is deposited on the machine; 5. Poor filtration.

The throttle is loose and the car is buzzing. Look at the buzzing position. If it is on the right side of the engine, there may be something wrong with the belt of the generator, the throttle, or the vibration phenomenon caused by the bracket or other parts of the engine. It is also possible that the exhaust pipe is broken.

The bearing of belt tensioner or idler will hum when it rings, but the reason why the oil collection will not ring is that the belt load increases when refueling, and the bearing load of belt tensioner or idler also increases. If their performance is not good, they will hum, and the corresponding wheels or assemblies need to be replaced immediately, otherwise the bearings will be burned to death and the belt will break.

* * * Vibration causes the car to hum when stepping on the gas pedal, and the oil collection does not ring. Generally, it will appear when the torque is insufficient, especially when the starting torque is low. You can increase the speed by stepping on the accelerator properly and then lifting the semi-linkage start, but this will also increase fuel consumption.

Reasons for the buzzing of automobile fuel filler door;

1, engine parts are not fully lubricated by engine oil, and the engine parts are lubricated evenly after running for a period of time;

2. If this phenomenon still exists after a period of time, it may be that the parts of the engine are seriously worn, and it is necessary to clean the inside of the engine to reduce the wear gap;

3, the gap is large, the seal is not good, the engine condition will be worse, and there may be ringing. It is recommended to go to the repair shop for inspection;

4. It may be caused by excessive carbon deposition on the machine, so you can go to the repair shop to clean it;

5. It may also be caused by poor filtration. The most common thing is that the air filter is too dirty, so you can go to the repair shop to clean or replace it.

6. If the purity of gasoline used is not enough, it will also cause this phenomenon, because gasoline with insufficient purity is easy to form carbon deposits inside the machine.

(Photo/Text/Photo: Ask and Answer Animals) @20 19