What's wrong with the frequent flameout in Jianghuai Ling Jun?

After driving a few kilometers, report to epc that the flameout is not good. After driving a few kilometers, report to epc that the flameout is not good. After driving a few kilometers, report to EPC that the flameout is not good. You are talking about the failure of the engine electronic stability system, and the failure light has been on all the time, resulting in flameout. The most common problem is the fuel label. There is something wrong with the quality of oil when refueling in small gas stations or private gas stations. In addition, check the intake system of the engine. If there is blockage or leakage, it is recommended to replace the air cleaner element of the engine. Excessive carbon deposition in the engine throttle will also cause the electronic stability system failure light, and the ecu failure will also lead to the engine electronic stability system failure, and the ecu needs to be refreshed. In fact, the above are all guesses. Specifically, it is best to read the fault code from 4s shops or specialized shops, and it is more common for the public to judge the fault EPC indicator light. After the key door is opened, the vehicle starts self-inspection, and the EPC indicator light will light up for a few seconds and then go out. If the vehicle does not go out after starting, it means that the mechanical and electronic system of the vehicle has failed. Generally speaking, EPC lights have two possibilities. First, the throttle is dirty and needs cleaning. In another case, the brake light is not on, so it is necessary to check the brake switch and wiring. Also, due to the oil problem, the EPC fault light will also light up. In addition, other reasons for automatic flameout: 1, poor fuel quality. Go to a regular gas station to refuel and use fuel with official labels. 2. Oil circuit problem. Clean the oil circuit, including fuel injector, throttle valve, fuel tank, etc. , and keep the oil circuit unblocked. 3. The engine speed sensor is too dirty. Remove the sensor and clean it. 1. If the car can't start after the light is on, it may be caused by the failure of the fuel pump or ignition components. Call for help directly. This is not a problem that the owner can solve. 2. The second is that the fault light is on, but there is no abnormality in driving. This may just be a sensor failure. In this case, you can continue driving temporarily, but it is best to drive slowly at medium and low speed. Of course, your destination needs to be changed. Go to the repair shop 3. The engine fault light is on, and the vehicle can run, but it has symptoms such as severe jitter and weak acceleration. Faced with this situation, don't summon up courage to take a chance, stop the car and call for help. It may be necessary to break the money and avoid disaster. @20 19