How to remove the throttle of Nissan Tiida?

How to disassemble and clean the Nissan Delta throttle: first remove the engine cover with 10 mm sleeve, and then remove the engine cover with 10 mm sleeve. Remove the air intake plastic pipe. Lever up the middle of the plastic clip with a screwdriver, gently pull out and remove the air inlet. Then remove the pipe from the intake hose and loosen the screw near the throttle clamp with an 8 mm sleeve.

Loosen the screw at the other end, and remove the air inlet hose between the air cleaner and the throttle valve, which can be removed only with light force. Remove the rubber hose of the carbon charging solenoid valve, clamp the clamp with pliers and pull it out. Remove the hose in this way, and the other two pipes of the throttle valve are also removed. Be careful that the water pipe will drip a little, so remove the throttle valve.

The key tool (ratchet wrench) came out, using an 8 mm sleeve, which was much more convenient. Otherwise, it would take a lot of effort, and the throttle valve was completely dismantled and still dirty. Be careful not to unplug the connecting plug with the throttle valve at this time, and keep the connecting pipeline firmly in contact with the throttle valve during the whole cleaning process. The whole throttle valve has been removed, and it is still dirty.

Be careful not to unplug the connecting plug of the throttle valve at this time. During the whole cleaning process, keep the connecting wire in close contact with the throttle valve. This is a 3M throttle (door) cleaner. It is best not to use carburetor cleaner. Adjust the movable trigger, change the direction of ratchet wrench, install throttle valve and connect all pipes. Pay attention to the wrong connection between the upper and lower pipes of the throttle valve. After cleaning and installation, the pipeline has been connected.