Does MG 6 need to match the engine computer?

Need an engine computer with MG 6 of Pacific Auto Network. MG 6 is a compact car owned by MG. The length, width and height of this car are 4704 mm (mm), 1848 mm (mm) and 1466 mm (mm) respectively, and the wheelbase is 27 15 mm (mm).

When the throttle is reset manually, the telephone switch can be switched on and off several times continuously, and the on-board computer will delete the original throttle memory and store new throttle data. If the verification is successful, the vehicle can be started, which means that the reset is successful. In addition, after the throttle of MG 6 car is replaced, it can also be equipped with a special diagnostic instrument for cars.

Throttle is a controllable valve that controls air to enter the engine. After air enters the intake pipe, it will be mixed with gasoline to form combustible mixture, thus forming combustion work. It connects the air filter and the engine block, and is called the throat of the automobile engine. There are three common methods for automobile throttle matching: manual matching, power-off matching and diagnostic instrument matching. Generally, zero is required after replacing a new throttle or disassembling and cleaning. The matching process is a computer self-learning process, which re-identifies the position and angle of the throttle.

The manual matching method of MG 6 throttle is as follows:

1, turn the key to the power gear first, and never start the car, that is, turn it off.

2. After standing for about 15 seconds, quickly step on the accelerator pedal to the end, be sure to step on it quickly, hold on for 15 seconds, and then quickly lift the pedal.

3. Then close the key door, take out the key and let it stand for about 15 seconds.

4. Start the vehicle normally and complete the matching.

(Photo/Text/Photo: Pacific Auto Network Q&A called Beast)