Illustration of Piglet Balloon Modeling Course

Piglet balloon modeling tutorial is as follows:

1, the balloon is inflated, leaving about 10cm at the tail. Starting from the mouth side of the balloon, tie an apple knot (pig nose) first. How to make an apple knot: first put the balloon mouth into the balloon with your right index finger, then grab the stuffed balloon mouth with your left hand and take it out with your right hand. A few more twists at the position of the balloon mouth will make the small apple knot.

2. Then screw a small single bubble A, screw a single bubble with a width of 4 fingers, screw a single bubble with a width of 4 fingers, screw a single bubble with a width of 4 fingers and fix it on the single bubble A. ..

3. Then, twist the two small bubbles in the triangle into an ear knot, then tie the apple knot and plug it into the triangle.

4. Then twist an ear knot and twist a double bubble.

Let's make the pig's body fatter and make a 3-bubble (first make a double bubble, then make a single bubble with the same length and stuff it in the middle).

6. Then make a double bubble and the rest make a pig's tail.

7. In this way, our lovely pig is ready. She draws mini eyes with gasoline. If you like a big nose, you can make the apple knot bigger.

A balloon is a sealed bag filled with air or other gases. Balloons can be used not only as toys, but also as vehicles.